FANCUT 106 HD MOST - plasma cutter

The FANCUT 106 HD device is used for high-quality cutting of metals up to 50 mm thick with a plasma air stream. Process control takes place from a modern panel with a liquid crystal display. In addition to adjusting the cutting current, you can set the operating mode (continuous cutting, grid cutting, or grooving). Also available are brightness adjustment, selection of pressure units, language, and information about the current status of the device. There are two modes for regulating the working pressure.
In automatic mode, the air working pressure is set synergistically according to the type of plasma torch, cutting current, and cutting mode. The pressure value is displayed but cannot be adjusted.
In manual mode, the pressure can be freely adjusted using a knob, and the value is shown on the display.
The working pressure is regulated by a built-in proportional valve, which minimizes the impact of fluctuations in input pressure. The "fan on demand" function activates the fan only when necessary, saving electricity and reducing dust contamination inside the cutter.
In standby mode, the FANCUT 106 HD consumes only 32 W.

*Values in parentheses refer to a 40 A network protection. Base values for 32 A protection.

Available accessories:

• Extension cable 6.0 m SV-105, SV-125 7 PIN - 59 26 00708A
• Silicone grease WSF-2 gross 6 g - 59 26 007101
• SVH-105 manual torch angle 15° 7 PIN - 59 26 007038
• SVH-105 manual torch length 80 cm angle 90° 7 PIN 7094-1 - 59 26 007094
• SVH-105 manual torch length 130 cm angle 90° 7 PIN 7095-1 - 59 26 00709A
• SVH-105 manual torch length 80 cm angle 15° 7 PIN 7096-1 - 59 26 00709B
• SVH-105 manual torch length 130 cm angle 15° 7 PIN 7097-1 - 59 26 00709C
• Bevel Tolls PT 40, 60, SCP 60, TH-70,125 beveling set - 59 26 005872
• SVH-105,125 circle cutting set - 59 26 007175
• AT 1000 filter set - 59 00 240036
• AT-1000 paper insert - 59 00 240037
• AT-1000 filter adapter (inlet-outlet connectors) - 59 00 240038

The device is supplied with a 32 A CEE plug. To achieve a cutting current of 105 A in a 100% duty cycle, it is recommended to connect the device to a 40 A protected network via a 63 A plug. Only an authorized person can change the plug.

Catalog sheet